Positive Retention Floor Mat - Mercury 2006 Mountaineer Owner's Manual

Driver Controls
Note: If the battery is disconnected, the power running boards default to
the OFF mode. The running boards must be turned on again, refer to
Message Center in this chapter.
Note: Do not use the running boards, front and rear hinge assemblies,
running board motors, or the running board under body mounts to lift
the vehicle with the jack, refer to Changing Tires in the Roadside
Emergencies chapter.
In extreme climates, excessive ice buildup may occur, causing
the running boards not to deploy. Be sure that the running
boards have deployed, and have finished moving before attempting to
step on them. Note: The running boards will resume normal function
once the blockage is cleared.
Turn off the running boards before working under the vehicle,
jacking, or placing any object under the vehicle. Never place
your hand in the hinge assemblies. A moving running board may cause
injury

POSITIVE RETENTION FLOOR MAT

Do not install additional floor mats on top of the factory installed
floor mats as they may interfere with the accelerator or the
brake pedals.
Position the driver floor mat so that
the eyelet is over the pointed end of
the retention post and rotate
forward to lock in. Make sure that
the mat does not interfere with the
operation of the accelerator or the
brake pedal. To remove the floor
mat, reverse the installation
procedure.
104
2006 Mountaineer (mnt)
Owners Guide (post-2002-fmt)
USA (fus)