Error Message Appears On A Pictbridge Compliant Device - Canon ip4700 series On-Screen Manual

Error Message Appears on a PictBridge Compliant Device

>
Advanced Guide Troubleshooting
Error Message Appears on a PictBridge Compliant Device
The following are the possible errors that may occur when printing directly from a PictBridge compliant
device and the countermeasures to clear them.
Note
This section describes errors that are indicated on Canon-brand PictBridge compliant devices. The
error messages and operations may vary depending on the device you are using. For errors on non
-Canon PictBridge compliant devices, check the status of the Alarm lamp and take the
appropriate action to clear the error. For details, see
For the errors indicated on the PictBridge compliant device and their solution, also refer to the
instruction manual of the device. For other troubles on the device, contact the manufacturer.
Error Message on the PictBridge
Compliant Device
"Printer in use"
"No paper"
"Paper Error"
"Paper jam"
"Printer cover open"
"No print head"
"Waste tank full"/"Ink absorber full"
"No ink"/"Ink cassette error"
"Ink Error"
"Hardware Error"
Downloaded from ManualsPrinter.com Manuals
> Error Message Appears on a PictBridge Compliant Device
Alarm Lamp Flashes Orange
If the printer is printing from the computer or warming up,
wait until the job ends.
When it is ready, the printer starts printing automatically.
Load paper, and select Continue* in the display on your
PictBridge compliant device.
* To resume printing, you can also press the
RESUME/CANCEL
Continue on the device.
If the Paper Output Tray is closed, open it. The printer
resumes printing. If the Inner Cover is opened, close it and
select Stop in the display on your PictBridge compliant
device to stop printing.
Select Stop in the display on your PictBridge compliant
device to stop printing.
Remove the jammed paper, load new paper, press the
RESUME/CANCEL
again.
Close the Top Cover on the printer.
The Print Head is defective or is not installed.
Five flashes:
See
the appropriate action.
The ink absorber is nearly full.
See Eight flashes:
the appropriate action.
The ink tank is not installed properly or empty.
Check the number of how many the Alarm lamp flashes and
take the appropriate action to resolve the error.
Alarm Lamp Flashes Orange
An ink tank that was once empty is installed.
Thirteen flashes:
See
take the appropriate action.
Ink tank errors have occurred.
Replace the ink tank.
Routine Maintenance
.
Action
button on the printer instead of selecting
button on the printer, then try printing
in Alarm Lamp Flashes Orange
in
Alarm Lamp Flashes Orange
in Alarm Lamp Flashes Orange
Page 404 of 437 pages
and take
and take
and
Page top