Screen Displays; Regular Displays - Panasonic AG-HVX202AEN Operating Instructions Manual

Screen displays

Regular displays

1 Time code displays
Each time you press the COUNTER button, the
display switches over to the following data (or
no indication).
COUNTER: (Tape or P2-camera mode only)
Counter value
M COUNTER: (Tape only)
Counter value in memory stop mode
TC:
Time code value. When the time code value
could not be read correctly from P2 card or
the tape, [TC ] is displayed.
UB:
User information
When user information could not be read
correctly from P2 card or the tape, [UB ] is
displayed.
FR:
Frame rate information for recording
FR 50I : Standard (50i interlace) mode (50
fields/sec.)
FR 50P : 50P progressive mode (50 frames/
sec.)
FR 25P : 25P progressive mode (25 frames/
sec.)
90
For details on the safety zone, refer to 36.
2 Warnings
REMOTE:
Blinks when the wrong equipment setting is
selected on the remote control unit.
:
Lights when condensation has formed inside
the camera-recorder.
:
Blinks when cylinder heads are dirty.
or :
P2
Blinks when a P2 card or tape has not been
inserted, or when the camera is in a write-
protected state.
FULL or END:
P2
Blinks when either there is no remaining
capacity in the P2 card or the tape has
reached the end.
LACK:
P2
Blinks in the loop rec mode when the
remaining capacity of the P2 card is
insufficient.
:
Lights when the internal battery for the
calendar has run out. (Page 59)
3 AUTO/MANUAL switch operation display
This display appears if a function which has
been set on the setting menu AUTO SW screen
is operating when the AUTO/MANUAL switch
has been pressed.