All Scan And Channel Lock Out; Shadow Watch Scan; Use The Foghorn; Shadow Watch Mode - NorthStar NS100 Reference Manual

All scan and channel lock out

When you are on a working channel, hold
While scanning, USA
down SCAN for at least two seconds to start
radio models will
scanning all working channels. CH16 (the
shadow watch on
priority channel) is scanned at least once every
CH70 for incoming
two seconds. ALL SCAN is shown on the LCD
DSC calls.
screen.
Press <ENT to lock out (skip over) an 'always
busy" channel when in ALL SCAN mode. An X
is shown on the LCD screen to indicate a locked
out channel. You cannot lock out CH16 or
CH70.

Shadow watch scan

The USA radio models use shadow watch mode
to scan for incoming DSC signals on CH70 in
any channel bank (USA, CAN, INT).
Shadow watch mode means that the scanning
operation is not shown on the LCD screen
unless a DSC signal on CH70 is detected.
Use the foghorn on the NS100DS
When visibility is reduced by fog, you can
operate a manual or automatic foghorn
through the external speaker. The manual
foghorn will sound whenever you press or hold
down PTT. The automatic foghorn will sound
for fi ve seconds once every minute.
You can also adjust the foghorn volume or
leave it at the default level.
1. Press FUNC then 9 to enter fog mode. FO is
2. Press >ENT to select the automatic foghorn
Quickstart Guide
16 Quickstart Guide
shown on the LCD screen.
OR
To unlock a locked out channel, press <ESC
2 seconds when the channel is displayed.
The X disappears to show it is now unlocked.
If a signal is received, scanning stops at that
channel and BUSY appears on the LCD screen.
Scanning starts again four seconds after the
BUSY annunciator disappears.
To stop at the current channel and cancel the
SCAN mode, press SCAN again or <ESC.
The European radio models have a dedicated
DSC CH70 receiver and don't use shadow
watch mode.
move the cursor to MANUAL and then press
>ENT to select the manual foghorn.
3. When the foghorn is blowing you can press
^VOL to increase or VOLv to decrease the
foghorn volume. The LCD screen will show
the current foghorn volume as a percentage
e.g. 50% VOLUME.
4. The foghorn's listening function allows
sounds picked up by the hailer horn to be
heard over the radio. When the LCD screen
shows LISTENING, you can press ^VOL to
increase or VOLv to decrease the volume.
Press <ESC when you want to exit from the
foghorn mode.
Northstar NS100