Brother DCP-J525W Basic User's Manual page 53

Error Message
Ink Absorber Full
InkAbsorberNearFull
Ink low
Low Temperature
Media Error
(DCP-J725DW)
Downloaded from ManualsPrinter.com Manuals
Cause
The ink absorber box or flushing box is
full. These components are periodic
maintenance items that may require
replacement after a period of time to
ensure optimum performance from
your Brother machine. Because these
components are periodic maintenance
items, the replacement is not covered
under the warranty. The need to
replace these items and the time
period before replacement is
dependent on the number of purges
and flushes required to clean the ink
system. These boxes acquire
amounts of ink during the different
purging and flushing operations. The
number of times a machine purges
and flushes for cleaning varies
depending on different situations. For
example, frequently powering the
machine on and off will cause
numerous cleaning cycles since the
machine automatically cleans upon
power up. The use of non-Brother ink
may cause frequent cleanings
because non-Brother ink could cause
poor print quality which is resolved by
cleaning. The more cleaning the
machine requires the faster these
boxes will fill up.
Note
Repairs resulting from the use of
non-Brother supplies may not be
covered under the stated product
warranty.
The ink absorber box or flushing box is
near full.
One or more of the ink cartridges are
near the end of their life.
The print head is too cold.
The memory card is either corrupted,
incorrectly formatted, or there is a
problem with the memory card.
Troubleshooting
Action
The ink absorber box or flushing box
will need to be replaced. Contact
Brother Customer Service or your
local Brother Authorised Service
Centre to have your machine serviced.
Other reasons for cleaning are:
1 The machine automatically cleans
itself after sitting idle for more than
30 days (infrequent use).
2 The machine automatically cleans
itself after the ink cartridges have
been replaced 12 times.
Call Brother Customer Service / your
Brother dealer.
Order a new ink cartridge. You can
continue printing until the LCD shows
Cannot Print. (See Replacing the
ink cartridges uu page 37.)
Allow the machine to warm up.
Put the card firmly into the slot again to
make sure it is in the correct position.
If the error remains, check the media
drive (slot) of the machine by putting in
another memory card that you know is
working.
B
45