Pushing The Machine By Hand; Using The Side Discharge - Toro TITAN ZX 4800 Operator's Manual

Pushing the Machine by Hand

Important: Towing the machine will damage the
drivetrain of the machine.
Always push the machine by hand.
To Push the Machine
1. Park the machine on a level surface and disengage the
blade control switch.
2. Engage the parking brake
3. Move the motion control levers outward to neutral lock
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
4. Locate the bypass levers at the rear of the machine, on
the left and right side of the frame.
5. Move the bypass levers rearward and then down to
lock them in place as shown in Figure 26 to disengage
the wheel motors.
Note: Ensure that the left and right bypass levers are
rearward and locked before moving the machine.
6. Disengage the parking brake
The machine is now able to be pushed by hand.
1
3
To Operate the Machine
Move the bypass to the position for operating the machine
(Figure 26) to engage the wheel motors.
2
4
G024554
Figure 26

Using the Side Discharge

The mower has a hinged grass deflector that disperses
clippings to the side and down toward the turf.
DANGER
Without a grass deflector, discharge cover, or
complete grass catcher assembly mounted in
place, you and others are exposed to blade contact
and thrown debris. Contact with rotating mower
blade(s) and thrown debris will cause injury or
death.
• Never remove the grass deflector from the mower
because the grass deflector routes material down
toward the turf. If the grass deflector is ever
damaged, replace it immediately.
• Never put your hands or feet under the mower.
• Never try to clear the discharge area or mower
blades unless you move the blade control switch
(PTO) to the off position, rotate the ignition key
to off and remove the key.
• Make sure the grass deflector is in the down
position.
24