Premaintenance Procedures; Raising The Seat; Lubrication; Greasing The Bearings - Toro TITAN ZX 4800 Operator's Manual

1. Read the Operator's Manual for information on maintenance.
2. Check the engine oil every 8 hours
3. Check the drive wheel tire pressure every 25 hours
Premaintenance
Procedures

Raising the Seat

Make sure the motion control levers are locked in the neutral
lock position. Lift the seat forward.
The following components can be accessed by raising the seat:
•
Service decal
•
Fuses
•
Battery and cables
Figure 27
Located on the seat pan underside
4. Check the hydraulic oil every 25 hours
5. Check the caster wheel tire pressure every 25 hours
6. Lubricate the caster wheel every 25 hours

Lubrication

Greasing the Bearings

Service Interval: Every 25 hours—Grease all lubrication
Grease Type: No. 2 General Purpose Lithium Base Grease
1. Park the machine on a level surface and disengage the
2. Move the motion control levers outward to the neutral
3. Clean the grease fittings with a rag (Figure 27 and
27
points.
blade control switch.
lock position, stop the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
Figure 28). Make sure to scrape any paint off of the
front of the fitting(s).