Input Setup; Setting The Digital In Assign; Setting The Ext In Sw Level; Setting The Input Function Level - Denon AVR-2106 Operating Instructions Manual

Advanced Setup – Part 1

Input Setup

Setting the Digital In Assign.

This setting assigns the digital input terminals of the AVR-2106
for the different input sources.
1
CURSOR D D H H
Press the or
"Input Setup" at the "System Setup" menu,
ENTER
then press the button.
• The "Input Setup" screen appears.
2
CURSOR D D H H
Press the or
"Digital In Assign.", then press the
button.
• The "Digital In Assign." screen appears.
3 CURSOR D D H H
Press the or button to select the
digital input terminal, then press the
F F G G
or button to select the input source.
Select "OFF" for input sources for which no digital input
terminals are used.
If "Yes" is selected for "Default", the settings are
automatically reset to the default values.
4
ENTER
Press the button to enter the setting.
• The "Input Setup" menu appears.
• The OPTICAL 3 terminal on the AVR-2106's rear panel is
equipped with an optical digital output terminal for recording
digital signals on a CD recorder, MD recorder or other digital
recorder. Use this for digital recording between a digital audio
button to select
source (stereo – 2 channels) and a digital audio recorder.
• Do not connect the output of the component connected to the
OPTICAL 3 OUT terminal on the AVR-2106's rear panel to any
terminal other than the OPTICAL 3 IN terminal.
• "PHONO", "TUNER" and "V. AUX" cannot be selected with
"Digital In Assignment".

Setting the Ext In SW Level

Set the method of playback of the analog input signal connected
to the Ext. In Subwoofer.
button to select
1
Press the
ENTER
In SW Level" at the "Input Setup" menu, then
press the
• The "Ext In SW Level" screen appears.
CURSOR
2
Press the
according to the specifications of the player
being used.
Also refer to the player's operating instructions.
+15 dB (default) recommended (0, +5, +10 or +15 can be
selected).
3
Press the
• The "Input Setup" menu appears.
CURSOR D D H H
or button to select "Ext
ENTER
button.
CURSOR F F G G
or button to select
ENTER
button to enter the setting.
36
ENGLISH
Advanced Setup – Part 1

Setting the Input Function Level

• Correct the playback level of the different input sources.
• Adjust the playback levels of the devices connected to the
different input sources to the same level to eliminate the need
for adjusting the main volume each time the input source is
switched.
1 CURSOR D D H H
Press the or
"Input Function Level" at the "Input Setup"
ENTER
menu, then press the button.
• The "Input Function Level" screen appears.
2
CURSOR D D H H
Press the or button to select the
input source, then press the
button to adjust the level.
The level can be adjusted between –12 dB and +12 dB in
units of 1 dB.
If "Yes" is selected for "Default", the settings are
automatically reset to the default values.
3
ENTER
Press the button to enter the setting.
• The "Input Setup" menu appears.
• After completing this setting, check that the playback levels for
the different sources are the same.
ENGLISH
button to select
CURSOR F F G G
or