Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
S
If installing the
COUT
- Operate the unit on a level surface to ensure proper lubrification to the water pump.
- Be certain the ambient temperature of the environment does not exceed 100°F. This ensures adequate air
supply for the burner,
- Do not expose the unit to rain, snow or freezing temperatures.
- Do not install where dust, vapors or combustible materials will be present.
PRE-OPERATION CHECK
CLOTHING
Proper clothing is essential for your safety. Use whatever is necessary to protect your eyes, ears, feet and skin.
Additional safely accessories (like a respiratory mask) may be required when using detergents with this washer.
PUMP
If oil is needed, fill with SAE 80-90 non-detergent oil AGIP ROTRA MULTI THT or correspondant products:
• U.T.T.O. Lubricants (Universal Tractor Transmission Oil)
• SHELL DONAX TD
• MOBIL MOBILFLUID 422
• FORD M2C-86 B - M2C-134B/C
• JOHN DEERE J20A
• MASSEY - FERGUSON M-1135
• ESSO TORQUE FLUID 62
• API GL-4
Quantity: 0,26 lb (do not overfill)
WATER SUPPLY
1.
Connect the water supply to the 3/4" female garden hose swivel on the water inlet port of the unit.
Connect the other end of the hose to the pressurized water supply. The supply hose should have a
3/4" inside diameter (ID) and be no longer than 50 feet.
2.
The water supply pressure must be a minimum of 20 pounds per square inch (PSI) and a
maximum of 125 PSI. The flow rate must be at least 3 gallons per minute (GPM).
3.
Use a water softener if there is high mineral content in the water of your area. High mineral
content causes excessive scale build-up in the coil/heat exchanger.
4.
Un-roll the hose reel and then connect one end of the high pressure discharge hose to the water-
gun assembly.
157596 indoors or in an enclosed area, observe the following guidelines:
!
Sudden release of high pressure streams can cause serious injury.
Be sure all connections are securely tightened.
- 6 -
Advertisement
Table of Contents
