Care Of Your Steam Mop - Shark S2901UKJR Owner's Manual

Care of Your Steam Mop

AFTER USE AND STORAGE
1
Press the power button to turn the unit off. Unplug
the cord from the outlet and place the mop into the
upright position. Let the unit cool for 2-3 minutes.
2
When you have finished using the Handheld Steamer,
reattach the handle to the handheld steamer.
14 www.sharkclean.eu/uk
fig. 16
3
Remove the cleaning pockets from the mop heads
by releasing the quick fasteners and using the loop
on the side of the pocket, avoiding contact with the
hot pocket or dirt.
4 Empty the water tank before storage. Remove the
water tank cap and empty the tank over a sink.
Replace the water cap.
5
To store the Shark ® Multi-Function Steam
Pocket Mop Lite hanging up, first remove the head
®
(after it has cooled and the steam has been released)
then hang on a large hook. (fig. 16)
40°
fig. 17
fig. 18
CARE OF YOUR CLEANING POCKETS
1 We recommend washing your cleaning pocket
separately from other fabrics to avoid picking up lint.
For optimal cleaning performance, the pockets may
need to be washed up to (3) three times. Only use
liquid detergent (no powder detergent). Do not
use any fabric softeners or bleach. Line dry. Do
not tumble dry. (fig. 17)
2
If there are loose threads on the cleaning pocket,
carefully cut the thread with scissors. Do not pull on
them or cut at the base. (fig.18)
IMPORTANT: The cleaning pocket may be very hot
from the steam. Use caution when removing. Let the
unit cool for 2-3 minutes.
DECALCIFYING YOUR STEAM MOP
Calcium and mineral deposits can build up and
impact the performance of your steam mop
over time. To extend the life of your product we
recommend that you use distilled water.
fig. 19
CLEANING THE NOZZLE
NOTE: To prevent clogging, it is recommended that
you periodically clean the Direct Steam Nozzle and
the extension hose stem.
1
Your Handheld Steamer should not normally require
cleaning, however, should you notice a decrease in
the steam output, it may be necessary to remove
mineral deposits built up around the nozzles.
2
Unplug the cleaner from the electrical outlet.
3
Use a small diameter stiff metal wire, such as a
straightened metal paperclip, and carefully insert the
end of the wire into the nozzle orifice. See illustration
above. (fig. 19)
4
Move the wire back and forth several times to remove
any deposits.
5
Plug in the appliance to the power outlet and test
steam output.
www.sharkclean.eu/uk 15