NordicTrack Elite 2500 User Manual page 9

4. Remove and discard the four indicated screws
(A). Remove the Tray (79) from the Upright
Crossbar (76).
5. Carefully slide the Upright Crossbar (76)
between the Uprights (84). Attach the Upright
Crossbar with four 5/16" x 3/4" Screws (1). Start
all four Screws, and then tighten them.
6. Hold the Tray (79) near the right Upright (84).
Wrap the tie in the hole in the side of the right
Upright around the end of the fan wire (B). Next,
pull the fan wire into the hole and out of the top
of the right Upright. Then, remove the tie.
Identify the #8 x 3/4" Screws (5). IMPORTANT:
Do not confuse the #8 x 3/4" Screws with the
#8 x 3/4" Truss Head Screws (24). The #8 x
3/4" Truss Head Screws have flatter heads.
Attach the Tray (79) to the Upright Crossbar (76)
with four #8 x 3/4" Screws (5). Start all four
Screws, and then tighten them.
4
A
79
5
1
84
6
B
Hole
Tie
5
84
9
76
A
76
1
84
79
76
5