Removing The Mem Card; Installing The Mem Card - Nortel 4065R User Manual

Accessories
To remove the battery pack:
1. Ensure that the handset is switched off.
2. Place the handset with the display down on a flat surface
3. Press the lever, as shown in Figure 7 (1), while lifting the battery up,
as shown in Figure 7 (2).
Figure 7: Removing the battery pack

Removing the MEM card

Use the following procedure to remove the MEM card from the handset.
Note: This procedure is required only if you plan to use the MEM card
with the optional MEM card tool.
To remove the MEM card:
1. Press the small tag b locks to release the MEM card.
2. Slide the MEM card out from under the two small crescents, as
shown in Figure 8 (1), and lift it out, as shown in Figure 8 (2).
Figure 8: Removing the MEM card

Installing the MEM card

Use the following procedure to install the MEM card into the handset.
84
2
1
a
2
1
b