Fiat Punto Owner's Handbook Manual page 23

Setting the speed limit (SPEEd)
With this function it is possible to set the
car speed limit (km/h or mph), when this
limit is exceeded the driver is immediate-
ly alerted (see section "Warning lights and
messages").
To set the speed limit, proceed as follows:
– briefly press button MENU ESC, the
display will show the wording (SPEEd) and
the unit (km/h) or (mph) previously set;
– press button + or – to select speed lim-
it activation (On) or deactivation (OFF);
– if the function has been activated (On),
press buttons + or – to select the re-
quired speed limit and then press MENU
ESC to confirm;
Note The possible setting is between 30
and 200 km/h, or between 20 and 125
mph depending on the unit set previous-
ly (see paragraph "Setting the distance unit
(Unit)") described later. Every press on
button +/– increases/decreases by 5 units.
Keeping the button +/– pressed obtains
the automatic fast increase or decrease.
When you are near the required setting
complete adjustment by single presses.
– briefly press button MENU ESC to go
back to the menu screen or press the but-
ton for long to go back to the standard
screen without storing settings.
To cancel the setting, proceed as follows:
– briefly press button MENU ESC: (On)
will flash on the display;
– press button – (Off) will flash on the dis-
play;
– briefly press button MENU ESC to go
back to the menu screen or press the but-
ton for long to go back to the standard
screen without storing settings.
Setting the clock (Hour)
With this function it is possible to set the
clock.
To set the clock, proceed as follows:
– briefly press button MENU ESC,
"hours" will flash on the display;
– press button + or – for setting;
– briefly press button MENU ESC, "min-
utes" will flash on the display;
– press button + or – for setting;
– briefly press button MENU ESC to go
back to the menu screen or press the but-
ton for long to go back to the standard
screen without storing settings.
Adjusting the buzzer volume
(bUZZ)
This function enables to adjust the volume
of the buzzer accompanying any fail-
ure/warning indication and the roger-beep
accompanying the activation of buttons
MENU ESC, + and –.
To adjust the volume proceed as follows:
– briefly press button MENU ESC, the
display will show the wording (bUZZ);
– press button + or – to select the re-
quired volume (volume can be adjusted ac-
cording to 8 levels).
– briefly press button MENU ESC to go
back to the menu screen or press the but-
ton for long to go back to the standard
screen without storing settings.
21