Configuration Screen - ZyXEL Communications PLA4101 User Manual

Chapter 4 The Configuration Utility

4.4 Configuration Screen

Use the Configuration screen to see which devices are recognized by your powerline network, to
configure your PLA and to set up a secure powerline network by changing the powerline network
name. This screen opens up when you launch the utility.
Figure 16 Configuration Screen
The following table describes the labels in this screen.
Table 10 Configuration Screen
LABEL
Network
Topology
The fields described below are used to identify the powerline adapters recognized on the powerline network.
The configuration utility automatically updates this information every 10 seconds.
Note: Only devices which share the same network name are displayed in this table.
Site
MAC Address
FW version
DAK Password
Scan
36
DESCRIPTION
Use this to select which powerline network information is displayed. Different powerline
networks are identified by the Ethernet interface (network card) connected directly to the
PLA. Typically there is only one connection, however, if your computer has two network
cards and both are connected to a powerline device then you have two powerline networks.
This field displays
• Local, if it is identifying the powerline adapter directly connected to the computer
running the configuration utility.
• Remote, if it is a powerline adapter in your powerline network but not directly
connected to the computer running the configuration utility.
This is a read-only field which shows the MAC address of the powerline adapter you are
configuring. You can find the MAC address of your PLA displayed on a sticker on the bottom
of your device.
This is a read-only field which shows the firmware version of the powerline adapter in your
network.
This is a read-only field which shows the DAK (Device Access Key) password of the remote
powerline adapter.
Click Scan to refresh the information in the table (immediately).
PLA Series User's Guide