ZyXEL Communications PLA4101 User Manual page 15

Press the RESET/ENCRYPT button at the side of your powerline device for 0.5 to 3 seconds. The
1
power ( ) light will blink as the powerline device tries to set up a connection with a new random
network name.
Figure 3 ENCRYPT Connection Procedure
PLA
Note: The RESET/ENCRYPT button's location varies for each Powerline model.
Note: Check the lights on the two powerline devices. The power (
lights should be on while the devices are connecting. Wait for about two minutes
while your powerline devices connect.
If the power ( ) light does not blink when you press RESET/ENCRYPT, you have probably
pressed the RESET/ENCRYPT button for too long. Try again, pressing the RESET/
ENCRYPT button for 0.5 to 3 seconds.
If the HomePlug (
devices are not connected. Repeat step 1 in this section. If that doesn't work, see the
Troubleshooting in Section 6.4 on page 51 for suggestions.
To add more powerline devices to your network, use any powerline device (A or B) you have
2
connected to set up a connection with the powerline devices you want to connect (C and D).
Press the RESET/ENCRYPT button on both powerline devices (A and C, or B and C) for 0.5 to 3
3
seconds to add powerline device C. This must be done within 2 minutes (120 seconds) of pressing
the RESET/ENCRYPT button on the PLA.
PLA Series User's Guide
press 0.5 ~ 3 seconds
within 2
minutes
) lights on both powerline devices do not light up, the powerline
Chapter 2 The RESET/ENCRYPT Button
PLA
press 0.5 ~ 3 seconds
) and HomePlug ( )
15