Step 3 - TuffStuff CLH-300 Owner's Manual

Step 3

Step 3
Item #
*3 LINEAR SHAFT HOUSING FRAME
22 FLAT WASHER SAE Z/P 3/8"
23 FLAT WASHER SAE Z/P 1/2"
24 SPLIT LOCK WASHER Z/P 3/8"
25 SPLIT LOCK WASHER Z/P 1/2"
27 HEX HEAD CAP SCREW GR-5 Z/P 3/8-16 X 1
34 HEX HEAD CAP SCREW GR-5 Z/P 1/2-13 X 1 1/2
NOTE:
1. SLIDE THE CARRIAGE TOWARDS THE BACK AND HOLD IT IN PLACE AS SHOWN BELOW.
2. HAVE THE OTHER PERSON BRING THE LINEAR SHAFT FRONT FRAME (#*3) INTO PLACE
WHILE YOU GUIDE THE LINEAR SHAFTS INTO PLACE.
3. BOLT DOWN.
Loosely Tighten Loosely Tighten
70% 70%
Loosely tighten all hardware in this step.
DO NOT Fully Tighten. Some component(s)
may need pre-assembly and or alignment
during the assembly process.
14
Assembly List
Description
www.tuff stuffi tness.com
Qty.
1
2
3
2
3
2
3
CLH-300 Horizontal Plate Load Leg Press/Hack Squat