Specifications; Safety Instructions - Makita 9067 Instruction Manual

ENGLISH
1 Wheel guard
2 Screw
3 Notch
4 Side grip
5 Shaft lock
6 Press
7 Lock nut

SPECIFICATIONS

Model
Depressed center wheel diameter ....................................... 180 mm
Spindle thread ...................................................................... M14
–1
No load speed (min ) ......................................................... 8,500
Overall length ....................................................................... 458 mm
Net weight ............................................................................ 4.2 kg
• Due to our continuing program of research and
development, the specifications herein are subject
to change without notice.
• Note: Specifications may differ from country to
country.
Power supply
The tool should be connected only to a power supply
of the same voltage as indicated on the nameplate,
and can only be operated on single-phase AC supply.
They are double-insulated in accordance with Euro-
pean Standard and can, therefore, also be used from
sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V
Switching operations of electric apparatus cause volt-
age fluctuations. The operation of this device under
unfavorable mains conditions can have adverse
effects to the operation of other equipment. With a
mains impedance equal or less than 0.31 Ohms it
can be presumed that there will be no negative
effects. The mains socket used for this device must
be protected with a fuse or protective circuit breaker
having slow tripping characteristics.
Safety hints
For your own safety, please refer to the enclosed

safety instructions.

Explanation of general view
8 Depressed center wheel
9 Inner flange
10 Lock nut wrench
11 Tighten
12 Switch trigger
13 Lock lever
14 Carbon brush
SAFETY INSTRUCTIONS
Warning! When using electric tools, basic safety
precautions should always be followed to reduce
the risk of fire, electric shock and personal injury,
including the following. Read all these instruc-
tions before attempting to operate this product
and save these instructions.
For safe operation:
1.
2.
3.
4.
5.
6.
7.
8.
15 Insulating tip
16 Commutator
17 Brush holder cap
18 Screwdriver
9067/9067S 9067SL
9067F/9067SF
180 mm
M14
6,600
458 mm
4.2 kg
Keep work area clean
Cluttered areas and benches invite injuries.
Consider work area environment
Don't expose power tools to rain. Don't use
power tools in damp or wet locations. Keep work
area well lit. Don't use power tools in presence of
flammable liquids or gases.
Guard against electric shock
Prevent body contact with grounded surfaces
(e.g. pipes, radiators, ranges, refrigerators).
Keep children away
Do not let visitors contact tool or extension cord.
All visitors should be kept away from work area.
Store idle tools
When not in use, tools should be stored in dry,
high, or locked-up place, out of the reach of chil-
dren.
Don't force tool
It will do the job better and safer at the rate for
which it was intended.
Use right tool
Don't force small tools or attachments to do the
job of a heavy duty tool. Don't use tools for pur-
poses not intended; for example, don't use circu-
lar saw for cutting tree limbs or logs.
Dress properly
Do not wear loose clothing or jewelry. They can
be caught in moving parts. Rubber gloves and
non-skid footwear are recommended when work-
ing outdoors. Wear protective hair covering to
contain long hair.
9069/9069S
9069F/9069SF
230 mm
M14
6,600
458 mm
4.3 kg
5