Nortel Versalar 5399 Quick Start Manual page 23

ACP Security on a Microsoft NT Server
To setup ACP security on a Windows NT Server, you can use native NT user
accounts. Each user must have local logon access rights and belong to a group that
has global authentication. The NT server must also have access to the domain's
Primary Domain Controller (PDC).
ACP Security on a UNIX Server
To setup ACP security on a UNIX server, perform the following:
Log on to the UNIX server as superuser.
1.
Create the password file /usr/annex/acp_passwd. The format for
2.
acp_passwd is the same as /etc/passwd.
To add a user's password enter
3.
Authentication Setup
Set up RAC to authenticate on the security server:
Log on to the RAC as superuser and run
1.
RAC by typing:
admin:
Set the RAC's ACP host.
2.
admin:
Leave cli security off so you can access the RAC from the console.
3.
admin:
Set vcli security.
4.
admin:
Reset the RAC for the configuration changes to take effect.
5.
admin:
After the RAC is reset, try to log on to the RAC through a telnet session.
6.
If security is working you may go ahead and set cli security using the
following admin command:
admin:
300855-C Rev. 00
set annex enable_security y
set annex pref_secure1_host <ip addr of ACP host>
set port cli_security n
set annex vcli_security y
reset annex all
set port cli_security y
username:: and then run ch_passwd.
admin . Enable security on the
Quick-Start Guide
11