Medisana EPD Manual page 29

3.6
Switching on
the device
3.7
Programme
selection
3.8
Starting a
program
3.9
Increasing/
reducing
the current
To switch on the device, press the On/off button
three seconds until your hear an acoustic signal. First all the symbols appear for
ca. 1 second in the display
The EPD device has 12 different programs, 1 - 8 for women and 9 - 12 for men.
Use buttons Prog+
of the program numbers, the device displays the body areas to be treated
and the corresponding program number P
is accompanied by a signal tone.
LIST OF PROGRAMS
No. program Body area
WOMAN
1 Moustache
2 Face
3 Tummy
4 Armpits
5 Bikini zone
6 Legs
7 Arms
8 Chest
MAN
9 Face
10 Tummy /Back
11 Armpits
12 Legs
Press the + button . Instead of the program number, the display shows the
symbol together with the duration of the treatment
and the bottom bar displaying the strength of current
the current strength, the program cycle begins with level 1, and the remaining
time of the program is displayed in minute increments.
You can change the strength of the current in 20 steps at any time, either at the
beginning of the program or when it is already underway.
To increase/reduce the current, press buttons +
only changes when the current is increased by two levels.
Make sure you read the following warnings!
. This shows that the device is in working order.
and Prog- to select a program. During the selection
. Every press of button
Duration
14 Min.
14 Min.
19 Min.
14 Min.
12 Min.
14 Min.
12 Min.
10 Min.
14 Min.
19 Min.
14 Min.
14 Min.
3 Application
and hold it for approx.
or
(10 - 19 minutes)
. Unless you regulate
and - . The bar display
GB
23