Before Use; Putting Into Operation - Bosch PFZ 1400 AE Operating Instructions Manual

pfz_gb_3609929854_t.fm Seite 2 Freitag, 18. Januar 2002 11:38 11

Before Use

Mounting the Loop Handle
Slide the spacer tube 16 into the housing
ten with the knob 15 B (Fig.
Spread the loop handle 2 somewhat
over both ends of the spacer tube
Insert the bolt 18 E and tighten with the knob 17
(Fig. ).
G
Adjusting the Loop Handle
Loosen the knob 17 and adjust the loop to the desired
inclination (Fig. ).
H
For sawing near the edge, slide the loop handle to the
side by loosening the knob 15 (Fig.
Retighten the knob or nut.
For the inserting of the saw blades, see Section
Changing Saw Blades.
Dust/Chip Vacuuming
Dust produced while working can be detrimental to
I
health, inflammable or explosive. Suitable protec-
tion measures are required.
Examples: Some dusts are considered to be carci-
nogenic. Use suitable dust/chip extraction and
wear a dust protection mask.
Hook on the channel for dust extraction 6 at the rear
under the handle and latch onto the catches 8. Insert
the vacuum hose (35 mm dia.) directly into the cou-
pling of the channel (Fig. K ).
The vacuum cleaner must be suitable for the material
to be worked.
When vacuuming dry dust that is especially detrimen-
tal to health or carcinogenic, use a special vacuum
cleaner.
3 609 929 854 • (02.01) T

Putting into Operation

Ensure that the mains voltage is correct!
A
and tigh-
The voltage of the power source must agree with the
).
E
value given on the nameplate of the machine. Ma-
chines designated for 230 V can also be operated with
C and place
220 V.
D (Fig. ).
F
F
I
I
).
I
Switching On/Off
Switching on:
Press the switch-on lock 4 to the left or right and hold,
then press the on-off switch 5.
I
Switching off:
Release the on-off switch 5.
Lay the machine down only after the saw blades have
come to a standstill.
After switching off, do not brake the saw blade to a
stop by applying side pressure.
Regulating the Stroke Rate
The stroke rate can be continuously adjusted with the
stroke rate regulator 3.
Setting 1:
Setting 6:
English–2
Do not drill, fasten or cut into blind areas
where electric, gas or water lines may exist.
Use appropriate detectors to determine if
these lines are hidden in the work area or call
the local utility company for assistance.
Contacting electric lines may cause fire or electric
shock. Striking a gas line will probably result in ex-
plosion. Breaking into a water pipe will cause prop-
erty damage or may cause an electric shock.
When switching on, the saw blades must not
be resting against, come in contact with or
strike anything!
Lowest stroke rate
Highest stroke rate