Advertisement
Specifications
HP
Output Torque
Voltage
Full Load Current (Amps)
Power (Watts)
Hertz
Phase
Overload Protection
Outlet Cord
Frame Gauge
Belt Size
Flywheel Weight (lbs.)
Flywheel RPM
Maximum Log Length
Maximum Log Diameter*
Cycle Time (sec.)
Splitting Force
Wedge Height
Wheel size
Machine Height
Machine Length
Machine Width
Weight
*The diameter listed is indicative of the maximum suggested size. A small log can be difficult to split when it contains knots or a
particularly tough fiber. On the other hand, it may not be difficult to split logs with regular fibers even if its diameter exceeds the
maximum indicated above.
Assembling the KINETIC LOG SPLITTER
Tools needed:
14mm Wrench (supplied with Splitter)
Note: The Frame Stand comes on the machine but needs to be rotated 180 degrees to be in the operating orientation.
1. Use a 14mm Wrench to remove the two Nuts and Lock Washers that hold the Frame Stand onto the Frame (Figure 2).
2. Remove the Frame Stand and rotate it 180 degrees. Reinstall it with the handle on the outside using the Nuts and Lock
Washers removed in step 1 (Figure 3).
Frame
Nut and
Lock Washer
( 1 per side)
Figure 2
®
GENERAC
8
G10 KINETIC LOG SPLITTER
2
.025 in-lbs @ Full Load
110
14.5
1060
60
1
Thermal Breaker
6'
3mm
A-1180
13
490
16"
12"
1
Out splits 5 ton Hydraulic
5"
6"
24.5"
49"
11.875"
132
Frame
Stand
Handle
Figure 3
Frame
Stand
Advertisement
