Advertisement
Chapter 4: Maintaining the KINETIC LOG SPLITTER
Regular maintenance is the way to ensure the best performance and long life of your machine. Please refer to this manual for
proper maintenance procedures.
Before performing any maintenance procedure or inspection, stop the motor, unplug the power cord and wait five minutes to
allow all parts to cool.
Regular Maintenance Checklist
P
ROCEDURE
Check General Equipment Condition
Perform Rail Maintenance
Check Belt
Check the condition of the electrical cord.
Grease Rack
Clean Motor Exterior and Cooling Fins
Top of Rail
Figure 11
®
GENERAC
12
G10 KINETIC LOG SPLITTER
B
E
E
EFORE
ACH
VERY
U
H
SE
OURS
▲
▲
▲
▲
▲
Lubrication
All Bearings of your Splitter are sealed units and should have sufficient lubricant
to last the life of your machine with normal use. Perform machine lubrication
per the following instructions.
Rail Maintenance
Between each use of the LOG SPLITTER, we recommend removing any debris
caught on the Rail or Ram and applying a rust preventative (Fluid Film or
equivalent) to any bare metal areas on the top of the Rail (Figure 11). This will
assure the smoothest return action of the Ram.
5
E
25
VERY
H
OURS
▲
Advertisement
