Advertisement
1/2"-5/8"
Pulley
Figure 15
Tension Nut
Motor Hardware
(2 per side)
Figure 16
Replacing the Belt
Tools and Supplies needed:
Phillips Screwdriver
14mm Wrench
17 mm Wrench
Belt: A1180
1. Remove the Center Guard, Flywheel Guard, and Belt Guard (see "Greasing the Rack" in this Chapter).
2. Loosen the Motor Hardware using a 14mm Wrench on the bolt and a 17mm Wrench on the nut (Figure 16).
3. Use a 17mm Wrench to loosen the Tension Nut until the Belt can be easily removed.
4. Install a new Belt onto the Pulley and Flywheel (Figure 15).
5. Tighten the Tension Nut against the Frame and follow the steps in the "Checking and Adjusting the Belt Tension" section to
set the Belt tension.
6. Tighten the Motor Hardware.
7. Reinstall the Guards.
®
GENERAC
14
G10 KINETIC LOG SPLITTER
Straight Edge
Adjusting and Replacing the Belt
Checking and Adjusting the Belt Tension
Flywheel
Note: The Belt performs best with a slight amount of slack as described below to
allow for the belt to slip on the pulley when the Wedge encounters a tough log. Too
much tension may stall the Motor.
Tools and Supplies needed:
1. Remove the Center Guard, Flywheel Guard, and Belt Guard (see "Greasing
Belt
2. Place a Straight Edge across the top of the belt (Figure 15).
3. Push on the top of the Belt with about 10 pounds of pressure. The Belt
4. Loosen the Motor Hardware using a 14mm Wrench on the bolt and a 17mm
5. Use a 17mm Wrench to turn the Tension Nut in against the Frame to
6. When the Belt is at the proper tension, tighten the Motor Hardware.
7. Reinstall the Guards.
Phillips Screwdriver
14mm Wrench
17 mm Wrench
the Rack" in this Chapter).
should deflect approximately 1/2" to 5/8". If the distance is not between
1/2" and 5/8", adjust per the following directions.
Wrench on the nut (Figure 16).
tighten (if Belt is too loose) or out to loosen (if Belt is too tight) for the
correct Belt tension.
Advertisement
