Table of Contents
Advertisement
6.3
Connection to the main water
supply kit (optional)
Before proceeding with the connection of the distributor to the
water main supply verify the following water characteristics:
– that it is drinkable (eventually through an laboratory's analysis
certification)
– it has a pressure comprised between 0.5 and 6.5 bar ( if this
should not be the case, use a pump or a water pressure, reducer
according to the case).
– install, if not present, a tap in an accessible position to isolate
the machine from the water mains should it be found to be
necessary (Fig.6.3).
– before making water connections, make some water flow out
of the tap so as to eliminate possible traces of impurities and
dirt (Fig.6.4)
– connect the cock to the distributor, using a pipe in nylon material
suitable for food products and suitable for the mains pressure.
In the event of the use of a flexible pipe it is necessary to fit
the reinforcement bush supplied inside (Fig. 6.5).
– the foreseen connection is a 3/ 4 gas (Fig.6.6).
Figure 6.7 illustrates the mains water supply connection dia-
gram.
For the installation operations related to the mains water supply
connection kit, please refer to the relative instruction sheet supplied
together with the kit itself.
Fig. 6.3
Fig. 6.5
Fig. 6.7
Fig. 6.6
18
Fig. 6.4
Hide quick links:
Advertisement
Table of Contents
