Using the device
Tuner DVB-T
Installation
Choose INSTALLATION option in the main menu, than
press OK. The following submenu options will appear:
Automatic search
Manula search
Antenna power
LCN
Using
buttons choose the needed submenu option and press OK to enter.
/
With
buttons choose the setting you wish.
/
To exit the menu, press EXIT.
Automatic search
After the searching is done, the tuner will show the first channel automatically.
Using CH+/ CH- buttons you can choose any channel you wish. You can also press OK
to check the list of TV channels available and choose the one you want to watch.
TV/ R button allows you to switch between television and radio.
Manual search
Choose the Channel scanning submenu to see the following options:
Searching mode: By channels or By frequencies
Here you can find a specific channel by giving its number
or its frequency. To find a channel by its number you must
enter the band, the channel number and the network.
To find a channel by its frequency you must specify this
frequency and the band range.
Channel No..: Channels 5~12 ( VHF) or 21~69(UHF)
Enter the specific number to find the desired channel.
This option is available only when the searching
‚
By channels
' option is ON.
Frequency: 174~230MHz (VHF) or 470~862MHz (UHF)
Enter the specific frequency to find the demanded channel.
This option is available only when the searching
‚
By frequencies
' option is ON.
Search
Press OK to enter the Search option and start the manual
searching
Signal strength
Signal quality:
The green bar showing the signal strength and the yellow bar showing the signal quality
allow you to trace the current TV signal status.
13