Nikon D300S User Manual page 172

6
Select preset d-0.
If the new value for preset white balance will be used
immediately, select preset d-0 by pressing the WB button and
rotating the sub-command dial until d-0 is displayed in the
control panel.
D
Direct Measurement Mode
If no operations are performed while the displays are flashing, direct
measurement mode will end in the time selected for Custom Setting c2
(Auto meter-off delay, 0 273).
A
Preset d-0
r
The new value for white balance will be stored
in preset d-0, automatically replacing the
previous value for this preset (no confirmation
dialog will be displayed). A thumbnail will be
displayed in the preset white balance list
(0 147).
To use the new value for white balance, select preset d-0 (if no value has
been measured for white balance before d-0 is selected, white balance
will be set to a color temperature of 5,200 K, the same as Direct
sunlight). The new white balance value will remain in preset d-0 until
white balance is measured again. By copying preset d-0 to one of the
other presets before measuring a new value for white balance, up to five
white balance values can be stored (0 147).
146