Nikon D300S User Manual page 150

Canceling Bracketing
To cancel bracketing, press the Fn button and rotate the main
command dial until the number of shots in the bracketing
sequence is zero (
panel. The program last in effect will be restored the next time
bracketing is activated. Bracketing can also be cancelled by
performing a two-button reset (0 182), although in this case the
bracketing program will not be restored the next time bracketing
is activated.
A
Exposure and Flash Bracketing
In continuous low speed and continuous high speed modes, shooting
will pause after the number of shots specified in the bracketing
program have been taken. Shooting will resume the next time the
shutter-release button is pressed. In other modes, one shot will be
taken each time the shutter-release button is pressed.
If the memory card fills before all shots in the sequence have been
taken, shooting can be resumed from the next shot in the sequence
Z after the memory card has been replaced or shots have been deleted to
make room on the memory card. If the camera is turned off before all
shots in the sequence have been taken, bracketing will resume from the
next shot in the sequence when the camera is turned on.
A
Exposure Bracketing
The camera modifies exposure by varying shutter speed and aperture
(programmed auto), aperture (shutter-priority auto), or shutter speed
(aperture-priority auto, manual exposure mode). If On is selected for
ISO sensitivity settings > ISO sensitivity auto control in modes e, f,
and g, the camera will automatically vary ISO sensitivity for optimum
exposure when the limits of the camera exposure system are exceeded.
Custom Setting e6 (Auto bracketing (mode M), 0 290) can be used to
change how the camera performs exposure and flash bracketing in
manual exposure mode. Bracketing can be performed by varying flash
level together with shutter speed and/or aperture, or by varying flash
level alone.
124
) and M is no longer displayed in the control