Rinse Aid - Bosch SHXN8U55SS Operating Instructions Manual

Rinse Aid

To achieve proper drying, always use a liquid rinse aid, even if your deter-
gent contains a rinse aid or drying additive.
Note: The dishwasher indicates low rinse aid by turning on the "Add Rinse Aid" indi-
cator light. If this light is on, you need to refill the rinse aid dispenser by following
the directions below.
Adding Rinse Aid
To avoid oversudsing or clogging, do not overfill the rinse aid dispenser.
Wipe up any spills with a damp cloth.
1 Add liquid rinse aid to the dispenser until it
is full (see Figure 11). Do not overfill.
2 Close the lid. Lid must be fully closed until
it clicks in order to seal.
3 Wipe up any excess rinse aid that may have
puddled when the dispenser reservoir is full.
The indicator light will go out a few moments after the
dishwasher door is shut. See next page for instruction
on how to adjust the amount of rinse aid dispensed.
Setting the amount of rinse aid used
The amount of rinse aid dispensed can be set from "r:00" to "r:06".
1 Press the [On/Off] button.
2 Hold down the "A" button (see page 18) and press [Start] until the
display indicates "d:00". Release both buttons.
3 Press the "A" button until the display shows "r:05".
4 Press the "C" button to select the desired setting.
"r:00" = dispenser is OFF
"r:01" = lowest setting
"r:02" = low setting
"r:03" = medium setting
5 Press [Start] to save the setting.
Note: Using rinse aid and setting the dispenser to "r:00" may result in longer
cycle times.
NOTICE
"r:04" = medium/high setting
"r:05" = high setting
"r:06" = highest setting
Figure 11
Figure 11
16