Adding Detergent And Rinse Aid - Bosch SHXN8U55SS Operating Instructions Manual

Problem
Streaks on 1. Incorrect rinse aid setting.
glassware or
residue on
the dishes
Dishes are 1. Rinse aid dispenser is empty.
not getting 2. Improper loading of dishes.
dry enough Note: Plastic or Teflon do not typically dry
as well as other items due to their inher-
ent properties.
Odor 1. Food debris is present at the bot-
tom of the dishwasher.
Note: Water 2. Food particles are present near
testing is done
the door seal.
in the factory.
3. Residual water is present at the bot-
Occasionally
tom of the dishwasher.
water may still
4. Drain hose is obstructed.
appear in dish-
washer at pur-
chase which
may create an
odor.
Dishwasher 1. Restriction in the water supply
not filling system.
with water or 2. Previous wash cycle was not com-
"Check water pleted.
supply" dis- 3. Delay start is active.
play lights up 4. Household water supply turned
off.
Fascia panel 1. Abrasive cleaner used.
discolored
or marked
Noise during 1. Dishes may not be arranged
wash cycle properly.
25
Cause Action
1. Depending on the hardness of
water, adjust the rinse agent dis-
penser. Refer to "Adding Detergent
and Rinse Aid" section in the man-
ual.
1. Add rinse aid - the use of rinse agent
improves drying, use the Auto cycle, use
the Sanitize option.
2. Rearrange load to ensure items are
not nesting (see "Loading the Dish-
washer" section of the manual).
Note: Select models offer an extra heat-
ing option to improve drying perfor-
mance.
1. Remove the filters and clean accord-
ing to the "Care and Maintenance" sec-
tion of the manual.
2. Refer to "Care and Maintenance" sec-
tion of the manual.
3. Ensure the unit has completely
drained from the last cycle.
4. Remove any obstructions from the
drain hose by calling qualified personnel.
Note: If odor still persists, run the Nor-
mal/Regular cycle until it flushes and
interrupt the cycle and place an 8 oz.
cup of distilled white vinegar solution on
the upper rack and then finish the cycle.
1. Ensure that the water supply valve
(typically located under kitchen sink)
is open and check that the water sup-
ply line has no kinks or clogs.
2. Refer to the "Operating the Dish-
washer" section of the manual.
3. Cancel the delay start or wait until
delay start time completes.
4. Turn on water supply.
1. Use mild detergents with soft
damp cloth.
1. Water circulation sound is normal, but
if you suspect items are banging into
each other or into the spray arms, refer
to the "Loading the Dishwasher" section
of the manual for optimal arrangement.