System Settings - Pioneer MVH-X189UI Owner's Manual

Menu Item
SUB.W CTRL*2*3
Cut-off frequency: [50HZ],
[63HZ], [80HZ], [100HZ],
[125HZ], [160HZ], [200HZ]
Output level: [–24] to [+6]
Slope level: [–12], [–24]
BASS BOOST
[0] to [+6]
HPF SETTING
Cut-off frequency: [OFF],
[50HZ], [63HZ], [80HZ],
[100HZ], [125HZ], [160HZ],
[200HZ]
Slope level: [–12], [–24]
SLA
[+4] to [–4]
*1 Not available when [SUB.W/SUB.W] is selected in [SP-P/O MODE] in the INITIAL settings
(page 6).
*2 Not available when [REAR/REAR] is selected in [SP-P/O MODE] in the INITIAL settings
(page 6).
*3 Not available when [OFF] is selected in [SUB.W].

SYSTEM settings

You can also access to these menus when the unit is turned off.
16
En
Description
Only frequencies lower than those in the
selected range are output from the
subwoofer.
Select the bass boost level.
Only frequencies higher than the high-pass
filter (HPF) cutoff are output from the
speakers.
Adjust the volume level for each source
except FM.
Each of the below combinations are set to
the same setting automatically.
• USB, iPod, ANDROID, and APP (iPhone)
• BT AUDIO, and APP (Android)
Menu Item
CLOCK SET
12H/24H
[12H], [24H]
AUTO PI
[ON], [OFF]
AUX
[ON], [OFF]
USB AUTO
[ON], [OFF]
BT AUDIO
[ON], [OFF]
APP (Only for MVH-289BT)
[ON], [OFF]
BT MEM CLEAR
[YES], [CANCEL]
BT VERSION
Description
Set the clock (page 5).
Select the time notation.
Search for a different station with the same
programming, even if using a preset
station.
Set to [ON] when using an auxiliary device
connected to the unit.
Select [ON] to automatically switch to
[USB] source when a USB device/iPod is
connected to the unit.
Select [OFF] when a USB device/iPod is
being connected to the unit just for
charging.
Set the Bluetooth signal on/off.
Set the Bluetooth APP mode on/off.
Clear the Bluetooth device data (device list,
PIN code, call history, phone book, preset
phone numbers) stored in the unit.
[CLEARED] appears when data is
successfully deleted.
Displays the system version of the unit and
the Bluetooth module.