Installing The Handset Charging Cradle; Installing The Battery Pack; Preparing The Handset For Use - Nortel T7406E User Manual

Chapter 3

Preparing the handset for use

Complete the procedures in this chapter to
• install the charging cradle
• install the battery pack
• charge the battery pack in the handset for the first time

Installing the handset charging cradle

Warning: You must complete the steps in this section when you first initialize a
base station and configure the first handset.
1 Plug the small end of the power adapter into the back of the charging cradle.
2
Plug the other end of the power adapter into an AC outlet near the location of the cradle.
3 Place the handset in the cradle to charge the battery.

Installing the battery pack

Complete this procedure if the battery pack is not already installed in your handset.
1
Use your thumb to slide the battery compartment cover down and off the back of the handset.
2 Position the battery pack in the bottom position inside the battery compartment.
3 Firmly press the top of the battery pack into place.
4
Replace the battery compartment cover.
19
User Guide