Dhcp - TP-Link TL-WR842N User Manual

Follow the instructions below to set up your Guest Network Storage Sharing:
1. Plug an external USB hard disk drive or USB flash drive into this Router.
2. Make sure the Service Status on the page "USB Settings -> Storage Sharing" is Started.
3. Make sure the Access shared storage with password on the page "USB Settings -> Storage
Sharing" is Enabled.
Click the Start button to start the Guest Network Storage Sharing.
4.
5. Click the Add New Folder to Share button to specify a folder to share for the guests.
There is one default user account that can access the Guest Network Storage Sharing. Clicking
Modify on Figure 4-28, there will pop up Figure 4-29, where you can change the password and
storage authority of the account.

Note:
1. If you want guests visit folders of Guest Network Storage Sharing with guest account, you
must enable Access shared storage with password on the page "USB Settings -> Storage
Sharing", or the guests can't access to the Guest Network Storage Sharing.
2. The max share folders number is 6. If you want to share a new folder when the number has
reached 6, you can delete a share folder and then add a new one.
4.8

DHCP

Figure 4-30 The DHCP menu
There are three submenus under the DHCP menu (shown in Figure 4-30), DHCP Settings,
DHCP Clients List and Address Reservation. Click any of them, and you will be able to
configure the corresponding function.
TL-WR842N 300Mbps Multi-Function Wireless N Router User Guide
Figure 4-29 Modify User Account of Guest Network
- 47 -