TP-Link TL-WR842N User Manual page 113

Default Gateway - Display the default gateway in colon-hexadecimal notation provided by

your ISP.
Click the Renew button to renew the IPv6 parameters from your ISP.
Click the Release button to release the IPv6 parameters from your ISP.
If your ISP gives you one or two DNS IPv6 addresses, select Use the following IPv6 DNS
Servers and enter the Primary IPv6 DNS and Secondary IPv6 DNS into the correct fields.
Otherwise, leave the default selection Get IPv6 DNS Server Automatically, and the DNS servers
will be assigned from ISP dynamically.
 Primary IPv6 DNS - Enter the DNS IPv6 address in dotted-decimal notation provided by your ISP.
 Secondary IPv6 DNS - Enter another DNS IPv6 address in dotted-decimal notation provided
by your ISP.

Note:
If you get Address not found error when you access a Web site, it is likely that your DNS servers
are set up improperly. You should contact your ISP to get DNS server addresses.
 Address Autoconfiguration Type - RADVD (Router Advertisement Daemon) and DHCPv6
(Dynamic Host Configuration Protocol for IPv6) Server.
 Site Prefix Configuration Type - The type of IPv6 address prefix.
Delegated - Get the IPv6 address prefix from the ISP automatically, and the device will
•
delegate it to the LAN.
Static - Configure the Site Prefix and Site Prefix Length manually. Please contact your
•
ISP to get more information before you configure them.
 LAN IPv6 Address - Display the LAN IPv6 address created by the device.
Click the Save button to save your settings.
TL-WR842N 300Mbps Multi-Function Wireless N Router User Guide
- 104 -