Network; Wan - TP-Link TL-WR842N User Manual

Step 2: Enter the PIN number from the client device in the field on the above WPS screen. Then
click Connect button.
Step 3: "Connect successfully" will appear on the screen of Figure 4-4, which means the client
device has successfully connected to the Router.
III. Enter the Router's PIN on your client device
Use this method if your client device asks for the Router's PIN number.
Step 1: On the client device, enter the PIN number listed on the Router's Wi-Fi Protected Setup
screen. (It is also labeled on the bottom of the Router.)
Step 2: The Wi-Fi Protected Setup LED flashes for two minutes during the Wi-Fi Protected
Setup process.
Step 3: When the WPS LED is on, the client device has successfully connected to the Router.
Step 4: Refer back to your client device or its documentation for further instructions.

Note:
1) The WPS LED on the Router will light green for five minutes if the device has been
successfully added to the network.
2) The WPS function cannot be configured if the Wireless Function of the Router is disabled.
Please make sure the Wireless Function is enabled before configuring the WPS.
4.5

Network

Figure 4-5 the Network menu
There are three submenus under the Network menu (shown in Figure 4-5): WAN, MAC Clone
and LAN. Click any of them, and you will be able to configure the corresponding function.
4.5.1

WAN

Choose menu "Network → WAN", you can configure the IP parameters of the WAN on the
screen below.
1. If your ISP provides the DHCP service, please choose Dynamic IP type, and the Router will
automatically get IP parameters from your ISP. You can see the page as follows (Figure
4-6):
TL-WR842N 300Mbps Multi-Function Wireless N Router User Guide
- 22 -