Before You Begin Cleaning; How To Use - Vax U85-I3-Be Let's Get Started

Before you begin cleaning

• Always switch off and unplug the vacuum cleaner before connecting or disconnecting the hose/attachments, or removing
and emptying the dirt container.
• The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat the thermostat
will automatically turn the vacuum cleaner off. If this happens, switch the vacuum cleaner off and unplug from electrical
socket. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the vacuum cleaner to
cool for approximately 1 hour (if you have cleaned the filters please wait 24 hours for the filters to fully dry before putting
back into the vacuum).
• Filters require cleaning at least every 3 months.
• If the vacuum cleaner is blocked, switch off and unplug before removing the blockage.
• When using the accessories always make sure the brushbar is switched to the off position.
IMPORTANT: When the vacuum cleaner is stood in the upright position or when using on stairs and the hose/tools,
the brushbar height adjust dial must be set to hard floor.

How to use

Twist the quick release
cord hook to release the
power cord.
Using the Hard Floor Adaptor
Apply the Hard floor adaptor for optimum results on hard floors.
The Hard Floor Adaptor can be used on any floor setting.
Lie vacuum cleaner on its
back exposing brushbar.
Choose your desired
carpet height or
hardfloor setting.
Align Hard floor adaptor
with base of vacuum
cleaner, push until its clicks
into place.
Using your machine
Plug in your machine and
push ON/OFF button to
switch on.
Don't over fill the dirt
container to avoid clogging
your filter.
TIP