Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Selecting installation place
Read completely, then follow step by step.
Indoor unit
There should not be any heat source, inflammable gas or stream near the unit.
There should not be any obstacles blocking the air circulation.
A place where air circulation in the room is good.
A place where drainage can be easily done.
A place where noise prevention is taken into consideration.
Do not install the unit near the door way.
Ensure the restrictions on installation specified in the indoor unit installation drawings are met.
Select a location which is firm enough for installation so that the device is not subjected to
vibrations.
The device should beinstalled at a distance of at least 1m from all other electrical devices and
installations, e.g. TV, radio,computer, etc.
There should not be any direct sunlight. If unavoidable, sunlight prevention should be taken
into consideration.
Outdoor unit
If an awning is built over the unit to prevent direct sunsight or rain,be careful that heat
radiation from the condenser is not obstructed.
There should not be any animal or plant which could be affected by hot air discharged.
Make sure that there is sufficient space as specified in the installation drawings.
Do not place any obstacles which may cause a short circuit of the discharged air.
Select a location which avoids causing a nuisance to neighbours from noise and air emissions
from device.
Select a location which is sufficiently well ventilated.
Never cover the air inlets and outlets.
The location must be sufficiently firm for installation and the prevention of vibrations.
There must be no risk presented by combustible gas or gas escaping as a result of corrosion.
Avoid a location where there is a high salt content.
Avoid a location which is heavily exposed to dust.
Avoid a location to which the general public have access.
Accessories
Indoor unit
A
Installation plate
1
5
B
Clip Anchor
C
Mounting plate fixing
5
screw ST3.9x25
1
D
Remote controller
E
Fixing screw for remote
2
controller holder
optional
ST2.9X10
parts
Remote controller holder
F
1
G
Dry battery AAA.LR03
2
Use the supplied installation accessories as required. The items necessary to install
NOTE:
this air conditioner are not included must be purchased separately.
Air freshening filter
H
1
(used to install on
Air filter)
1
Seal
I
(for cooling & heating
models only)
Drain joint
J
,
Ower s manual
1
K
Installation manual
L
1
Remote controller
M
1
illustration
3 3
Indoor & outdoor unit installation drawings
Installation plate fixing
screw ST3.9x25(5)
Clip Anchor(5)
D
SET TEMPERATURE
( C)
AUTO
FAN
COOL
HIGH
DRY
MED
Remote
HEAT
LOW
TEMP
controller
MODE
ON/OFF
FAN SPEED
SWING
SLEEP
TIMER ON
TIMER OFF
RESET LOCK
AIR
DIRECTION
LED
DISPLAY TURBO
E
Fixing screw for
remote controller
holder ST2.9X10
F
Before screwing the remote
controller holder to the wall,
make sure that control signals
are properly received by
indoor unit.
A
B
In sites with poor drainage, use
block bases for outdoor unit.
Adjust its height until the unit
is leveled. Otherwise, water
leakage or pooling of water
may occur.
NOTE: Appearance of outdoor unit and indoor unit may differ from some models.
The actual shape shall prevail.
INSTALLATION INSTRUCTIONS
The mounting plate should be installed on a wall
which can support the weight of the indoor unit.
Additional drain pipe
H
Wrapping tape(wrap the
insulation pipe with the tape
from bottom to top)
C
Allow two of A, B and C
directions to be free
from obstructions.
Where there is a danger of the
unit falling, use foot bolts to
fix.
Fig.1
4 4
Advertisement
Table of Contents
