Stihl FSE 52 Instruction Manual page 27

Adjust handle to suit your height and
–
reach.
Check correct operation of handle
–
adjustment – see "Adjusting the
Handles" and "Adjusting Angle of
Control Handle".
To reduce the risk of accidents, do not
operate the unit if it is not properly
assembled and in good condition.
Do not operate your power tool if any of
its components are damaged or not
properly mounted.
Never attempt to modify the controls or
the safety devices in any way.
Before switching on your power tool,
make sure the cutting attachment is not
touching the ground or any other object.
To reduce the risk of
injury, avoid contact with
the cutting attachment.
Note that the cutting
attachment continues to
run for a short period
after the power tool is
switched off – flywheel
effect.
FSE 52
Electrical Connection.
Reduce the risk of electric shock:
Voltage and frequency of the
–
machine (see rating plate) and the
voltage and frequency of your
power supply must be the same.
Check the connecting cord, plug
–
and extension cord for damage.
Never use damaged cords,
couplings and plugs or connecting
cords that do not comply with
regulations.
Always connect the power tool to a
–
properly installed wall outlet.
Check that the insulation of the
–
power cord, extension cord, plug
and coupling is in good condition.
Never touch the mains plug, power
–
cord, extension cord or electrical
connections with wet hands.
Make sure the extension cord used
–
complies with the regulations for the
intended application.
Position the connecting and extension
cords correctly:
Check minimum cross section of
–
wires (wire gauge) – see
"Connecting to Power Supply".
To reduce the risk of stumbling,
–
position and mark the connecting
cord so that it cannot be damaged
or endanger others.
Using unsuitable extension cords
–
can be dangerous. Use only
extension cords approved for
outdoor use which are labeled as
such and have the appropriate wire
gauge.
The plug and coupling of the
–
extension cord must be splash-
proof and must never be immersed
in water.
Do not chafe on edges, pointed or
–
sharp objects
Do not squeeze through gaps in
–
doors or windows
If cords are twisted – unplug the
–
power tool and straighten them out
Never touch the rotating cutting
–
attachment
Always unwind the extension cord
–
completely from the cable drum to
reduce the risk of fire from
overheating.
Holding and Controlling the Unit
Always hold the unit firmly with both
hands on the handles. Make sure you
always have good balance and secure
footing.
Right-handers
Left hand on the loop handle and right
hand on the control handle.
English
25