Assembly Instructions - AEG VL 5525 M Instruction Manual

English
24
NOTE:
There may still be dust or production residues on the
surface of the device. We recommend that you quickly
wipe off the housing with a damp cloth.

Assembly instructions

The device must be completely assembled before use!
While reading the text it is advisable to refer to the
„Overview of the Components".
1. Place the stand tube (7) in the base (8).
2. Insert the washer (9) on the underside of the base.
3. Tighten the fastening screw (10) in a clockwise direc-
tion.
4. Position the rear protection grid (12) in place in ac-
cordance with the recesses.
NOTE:
Please ensure that the carrying handle is facing
upwards.
5. Turn the attachment ring (13) for the rear protection
grid (12) slightly in a clockwise direction.
6. Place the propeller in position and tighten it with the
retaining screw (2).
CAUTION:
The screw (2) has to be positioned on the fl attened
section!
7. Attach the front protection grid (15) by inserting the
hook (1) with the groove into the rear protection
grid.
NOTE:
Ensure that the holes for the attachment screw in
the front and rear protective grille are aligned one
above the other.
8. Close the attachment hooks .
9. Secure the protection grid with the fastening screw
(16) and the nut (11).
Position
The ideal position is a non-slip, fl at surface.
Putting into Service
Electrical Connection
1. Before inserting the plug into the socket. Make sure
that the mains voltage to be used matches that of
the device. You can fi nd this information on the
nameplate.
2. Connect the device to a duly installed 230V/50Hz
protective contact socket.
05-VL 5525 M.indd 24 05-VL 5525 M.indd 24
Use
Basic Settings
Set the blower inclination angle before starting the
device. You can adjust the inclination angle by tipping
the blower casing with both hands.
CAUTION:
The inclination angle amounts to approx. 15°.
Rotary Switch
On the rotary switch you can select the following set-
tings:
o 1 slow
o 2 medium
o 3 fast
o 0 off
Shift to „0" to switch off the device.
Fan Setting
For this you have two possibilities:
Fixed
• Turn the device off .
• Pull out the adjustment knob.
• Hold the fan by the protective cage and turn it in the
desired direction.
Oscillating
• Press in the adjustment knob.
• The device swivels automatically within a range of
approximately 60°.
• Pull the adjustment knob in order to switch the func-
tion off .
Cleaning
WARNING:
• Always remove the mains plug before cleaning the
device.
• If you need to remove the safety guard: Always
switch the device off and remove the mains plug.
• Under no circumstances should you immerse the
device in water for cleaning purposes. Otherwise
this might result in an electric shock or fi re.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• Clean the outside of the device with a dry cloth
without any additives.
• If the device is very dirty wet a cloth with water and
then wipe the device dry once you have fi nished.
Noise development
The workplace-related emission value is less than
70 dB(A).
24.11.2008 9:33:04 Uhr 24.11.2008 9:33:04 Uhr