Listening To The Radio - AEG SR 4357 BT Instruction Manual

English
36
Special safety information
This device works with a class 1 laser.
Overview of the Components
1 Handle
2 Telescopic antenna
3 CD compartment
4 Tab for opening the CD tray
5 USB CHARGING connection
6 SKIP-/SKIP+ buttons
7 VOL-/VOL+ buttons
8 Display
9 MODE / MEM / FOLDER button
10 PLAY/PAUSE button
11 POWER/SOURCE button
12 STOP / M+ button
13 USB PLAYBACK port
Reverse (not shown)
AC Mains connection
PHONES headphone jack
AUX-IN input
Underside (not shown)
Battery compartment
Start-up of the device/introduction
• Select a suitable location for the device, such as a dry,
flat, non-slip surface on which it is easy to operate the
machine.
• Ensure that the device is sufficiently ventilated!
• Remove the protective film from the display if it is still
present.
Power Supply
• Connect the power cable supplied (see battery compart-
ment if necessary) to a properly installed safety power
socket and the mains connector AC on the back of the
machine.
• Ensure that the voltage is the same as that indicated on
the model identification plate.
Inserting the Batteries (not supplied)
• Open the lid of the battery compartment on the bottom.
• Insert 6 batteries of type UM2/R14 1.5 V. Please ensure
that the polarity is correct (see the floor of the battery
compartment)!
• If the device is not used for a long period of time, remove
the batteries to avoid the spilling of battery acid.
• Then close the battery lid.
NOTE:
When a mains cable is connected the batteries are auto-
matically switched off.
CAUTION:
• Different battery types or new and used batteries must
not be used together.
• Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer' s .
WARNING:
The batteries shall not be exposed to excessive heat such
as sunshine, fire or the like. Danger of explosion!
Transport Safety Device, CD Compartment
• Open the CD compartment (3) by pulling the lid upwards
by the tab (4).
• Before operating the machine for the first time, remove
the transport safety device from the CD player if it is still
in place.
Volume
You can set the desired volume with the VOL-/VOL+
buttons (7).
Turning device on/ off
• Press the POWER/SOURCE button (11) to turn the device
on.
• To turn off the device, keep the POWER/SOURCE button
pressed for approx. 3 seconds.
NOTE:
After about 10 minute without a signal, the device will
automatically switch to standby.

Listening to the Radio

1. Select the radio mode with the POWER/SOURCE button
(11).
2. Completely extend the telescopic antenna. Change its
position to improve the reception.
3. Manual scan for radio stations:
Briefly press the SKIP-/SKIP+ button (6), until you have
found the radio station which you are looking for. If you
keep one of the buttons pressed down, the device will
search to the previous, respectively next radio station.
Preset station:
1. Search for the desired radio station with the SKIP-/
SKIP+ button (6).
2. To store the radio station, press the MODE/MEM/
FOLDER button (9). The notification "P 01" flashes on
the display.
3. Use the SKIP-/SKIP+ buttons to select the desired
preset location.