Cooling System - Pagsta BOBBER User Manual

COOLING SYSTEM

[Adding Coolant]
The coolant consists of refrigerant and distilled water, and has the function of anti-freezing. The coolant will prevent
the engine from overheating in neutral rotation or rotating in low speed.
We reccommend a 50/50 mix of Ethyl Glycol and distilled water. You will need about 1600ml for a complete flush.
1. Place the motorcycle on flat ground, unfold the kick stand. Drain the current fluid.
2. Unscrew the radiator cap, and pour the coolant into the radiator until it is filled.
3. Screw the cap on the radiator tightly.
4. Start the motorcycle . When the temperature of the coolant reaches about 180 degrees, stop the engine for 5
minutes, then open the radiator to pour more coolant until it is filled. Screw the cap tightly. Pour the coolant in this
way three times to make certain you have achevied the optimum level.
5. The total capacity of coolant will be about 1600ml.
Radiator cap
Overflow cap
36
Water pipe Sensor