Drive Chain Check, Adjustment And Lubrication - Pagsta BOBBER User Manual

DRIVING CHAIN CHECK, ADJUSTMENT AND LUBRICATION
[Driving Chain Cheek]
Check for wear of the drive chain
needed. Use the center stand to support the motorcycle, and step
on the gearshift pedal to shift into neutral. Place your finger
between both front and rear wheels, and swing the chain
up and down to adjust the chain to 10-20mm.
(Drive Chain Adjustment)
This motorcycle drive chain adjusts automatically with the
tension of the chain control by tension adapter. Spring
automatically adjust to the location of the tension wheel. You
should change the tension wheel if it was damaged.
[Driving Chain Lubrication]
Remove a chain lock clip
chain with detergent solvent and then dry it. Check for wear and damage of every part of the
chain. If necessary, replace it. Lubricate the chain with an appropriate amount of motor oil
or chain lubricant oil. Install the driving chain in the reverse order of disassembly and
adjust it.
NOTE: WHEN INSTALLING THE CHAIN LOCK CLIP, KEEP THE MOUTH OF THE
CLIP OPPOSITE TO THE NORMAL MOVING DIRECTION.
. Lubricate it when
with pliers carefully and disassemble the chain. Clean the
28
will
1
2
¢Ú
¢Ù
3
Tension Wheel
¢Û