Bosch GDR 9,6 V Original Operating Instructions page 9

OBJ_BUCH-608-001.book Page 9 Thursday, December 6, 2007 4:35 PM
Cordless Impact Screwdriver
Article number
Rated voltage
No-load speed
Impact rate
Maximum torque, hard screwdriving application
according to ISO 5393
Bolt size
Tool holder
Weight according to EPTA-Procedure 01/2003
Please observe the article number on the type plate of your power tool. The trade names of individual tools may vary.
Assembly
Battery Charging
A new battery or a battery that has not been used
for a longer time produces full power only after
approximately five charge/discharge cycles.
To remove the battery 5, press the unlocking but-
tons 6 and pull out the battery downwards. Do
not exert any force.
The battery is equipped with an NTC tempera-
ture control which allows charging only within a
temperature range of between 0 °C and 45 °C. A
long battery service life is achieved in this man-
ner.
A significantly reduced working period after
charging indicates that the battery is used and
must be replaced.
Observe the notes for disposal.
Changing the Tool (see figure A)
Before any work on the power tool (e. g.,
maintenance, tool change, etc.) as well as
during transport and storage, set the rota-
tional direction switch to the center posi-
tion. Unintentional actuation of the On/Off
switch can lead to injuries.
Bosch Power Tools
GDS 12 V GDS 14,4 V
Professional Professional
0 601 909 K.. 0 601 909 H.. 0 601 909 F..
V= 12
rpm 0 – 2800 0 – 2800
0 – 3200 0 – 3200
rpm
Nm 175
mm M6 – M14 M6 – M16
½ "
kg 1.8
GDR 9,6 V/GDR 12 V/GDR 14,4 V/GDR 18 V:
Inserting
Pull the locking sleeve 2 forward, push the insert
tool to the stop into the tool holder 1 and release
the locking sleeve 2 to lock the insert tool.
For quick changing of bits, it is recommended to
use a universal bit holder 11.
Removing
Pull the locking sleeve 2 forward and remove the
insert tool.
GDS 12 V/GDS 14,4 V/GDS 18 V:
When you install the tool bit, take care that
the tool bit is seated securely on the tool bit
holder. If the tool bit is not joined securely to
the tool bit holder, it may become loose and it
may no longer be controllable.
Slide the application tool onto the square drive
of the tool holder 1.
English | 9
GDS 18 V
Professional
14.4 18
0 – 2800
0 – 3200
200 220
M6 – M20
½ " ½ "
1.9 2.2
1 609 929 M69 | (6.12.07)