Table of Contents
Advertisement
burn your skin.
8.
Observe the instructions of the manufacturer
for correct mounting and use of wheels.
Handle and store wheels with care.
9.
Check that the workpiece is properly
supported.
10. If working place is extremely hot and humid,
or badly polluted by conductive dust, use a
short-circuit breaker (30 mA) to assure opera-
tor safety.
11.
Do not use the tool on any materials contain-
ing asbestos.
12. Always be sure you have a firm footing. Be
sure no one is below when using the tool in
high locations.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product. MISUSE or failure to follow the safety
rules stated in this instruction manual may cause
serious personal injury.
FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the tool is
switched off and unplugged before adjusting or
checking function on the tool.
Switch action
CAUTION:
Before plugging in the tool, always
check to see that the tool is switched off.
To start the tool, move the switch to the ''I'' (on) position.
To stop, move the switch to the ''O'' (off) position.
► 1. Switch
ASSEMBLY
CAUTION:
switched off and unplugged before carrying out
any work on the tool.
Installing or removing wheel point
Optional accessory
CAUTION:
the wheel point which you intend to use.
NOTICE:
Do not tighten the collet nut without
inserting a wheel point. Otherwise it can lead to
breakage of the collet cone.
Loosen the collet nut counterclockwise and insert the
wheel point into the collet nut. Use one wrench to hold
the spindle. With using another wrench, turn the collet
nut clockwise to tighten securely.
1
► 1. Wrench 2. Collet nut 3. Spindle 4. Collet cone
NOTE: If you cannot insert the wheel point into the
collet nut after loosening the collet nut, the collet cone
1
may obstruct the wheel point. In that case, remove
the collet nut and reposition the collet cone.
The wheel point should not be mounted more than 10
mm from the collet nut. Exceeding this distance could
cause vibration or a broken shaft.
10 mm (3/8")
5 ENGLISH
Always be sure that the tool is
Use the correct size collet cone for
4
2
1
3
Advertisement
Table of Contents
