Table of Contents
Advertisement
Code
The code prevents your dryer being
used without your knowledge.
When the code has been activated, you
have to enter a code after switching the
dryer on. Otherwise the dryer cannot be
operated.
Options
Factory default: off
Code on
If option has been selected, after
switching on you will have to enter the
code before you can operate the dryer.
To use the dryer when the code is
activated
After the dryer has been switched on,
will flash in the time display.
The code is and cannot be altered.
Touch the sensor until a
flashes in the first position.
Confirm this by pressing the Start/
Stop button.
Enter the two other numbers in the
same way.
The dryer is ready for use after has
been entered and confirmed.
Programmable functions
Conductivity
This programmable function
should only be set if the residual
moisture reading in your laundry is
incorrect due to extremely soft water.
Conditions
This programmable function should
only be set if the water used for
washing the laundry is extremely soft
with a conductivity reading (electrical
conductivity) less than 150 μS/cm.
Contact your local water authority for
the conductivity level of your mains
water supply.
Only activate this programmable
function for the conditions described
above.
Otherwise drying results can be
unsatisfactory.
Options
Factory default: off
Low conductivity
73
Advertisement
Table of Contents
