Table of Contents
Advertisement
Problem
lights up at the end
of a programme
and light up after
a programme has been
cancelled
lights up after a
programme has been
cancelled
lights up
Bars flash in the display
at the end of a
programme:
.........
Cause and remedy
There is a build-up of fluff in the airways.
Clean the fluff filters.
Clean the plinth filter.
See "Cleaning and care".
To switch off:
Open and close the door while the dryer is
switched on.
An excessive amount of fluff has built up.
Clean the fluff filters.
Clean the plinth filter.
Clean the airways:
– Clean the area underneath the plinth filter.
– Clean the heat exchanger.
To switch off:
Switch the dryer off and back on again.
The condensed water container is full or there is kink
in the drain hose.
Empty the container.
Check the drain hose.
To switch off:
Open and close the door while the dryer is
switched on.
The programme selector has been moved.
Select the original programme. The time remaining
will appear in the display again.
The programme has finished but the laundry has not
yet cooled down.
Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
Problem solving guide
45
Advertisement
Table of Contents
