Troubleshooting And Maintenance - NordicTrack NTSY59210 User Manual

TROUBLESHOOTING AND MAINTENANCE

Make sure all parts are properly tightened each time you use the weight system. Replace any worn parts immedi-
ately. The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight
system, can stretch slightly when it is first used. If
there is slack in the cables before resistance is felt,
the cables should be tightened. Make sure that the
cables are not too tight, or the Top Weight (32) will be
lifted off the weight stack.
Slack can be removed from the cables by tightening
the bolt at the end of the Rear Cable (103) into the
Top Weight (32). To do this, loosen the M12 Nut (96)
on the bolt. Turn the bolt a few turns into the Top
Weight, until there is no slack in the cables. Retighten
the M12 Nut against the M12 Washer (76).
Additional slack can be removed by moving the lower
115mm Pulley (54) in a pair of Pulley Plates to a
higher hole, or the upper 115mm Pulley to a lower
hole. Remove the M10 Nylon Locknut (93) and the
M10 x 50mm Bolt (77) from the Cable Trap (52),
Pulley, and Pulley Plates. Re-attach the Pulley and
Cable Trap with the Bolt and Locknut. Make sure
that the Cable Trap is positioned to hold the
Cable in place, and that the Cable and Pulley
move smoothly.
Note: If a cable tends to slip off the pulleys often,
the cable may have become twisted. Remove the
cable and re-install it.
If the cables need to be replaced, see ORDERING
REPLACEMENT PARTS on the back cover of this
manual.
32
35 54
93
54
25
103
96
76
52
35
77
52