MTU 12 V 2000 M84 Operating Instructions Manual page 21

The stated tightening torques M
and oiled, or galvanized, and to banjo screws made of copper/aluminum alloys.
Threads and mating faces beneath heads must be coated with engine oil prior to assembly.
An assembly tolerance of +10% of the figures in the table is permitted due to unavoidable deviations
during the tightening process.
Tightening torques for steel banjo screws
Thread
M8 x 1
M10 x 1
M12 x 1.5
M14 x 1.5
M16 x 1.5
M18 x 1.5
M22 x 1.5
M26 x 1.5
M30 x 1.5
M38 x 1.5
M45 x 1.5
M = tightening torques
A
Tightening torques for banjo screws made of copper-aluminum alloy
Thread
M10 x 1
M16 x 1.5
M = tightening torques
A
apply to steel (St) banjo screws with a phosphatized surface coating
A
Screwed into steel/gray cast iron/Al alloy M
Screwed into steel/gray cast iron/Al alloy M
MS150063/02E 2014-03 | General Information | 21
A
(Nm)
10
15
20
25
25
30
60
90
130
140
160
A
(Nm)
15
30