NordicTrack NTC07940 User Manual page 8

8. Attach the Backrest (62) and the Seat Back (98) to
the Backrest Frame (42) with two M6 x 20mm Button
Screws (20), an M6 x 45mm Button Screw (80), and
an M6 Washer (60).
Slide the Backrest Frame (42) onto the Seat Frame
(7). Attach the Backrest Frame with four M8 x 25mm
Button Screws (79) and four M8 Split Washers (55).
9. Identify the Left Pedal (22), which is marked with an
"L." Using an adjustable wrench, firmly tighten the
Left Pedal counterclockwise into the Left Crank Arm
(24). Tighten the Right Pedal (not shown) clockwise
into the Right Crank Arm. Important: Tighten both
Pedals as firmly as possible. After using the
exercise cycle for one week, retighten the
Pedals. For best performance, the Pedals must
be kept tightened.
Identify the Left Pedal Strap (25), which is marked
with an "L." Attach the Left Pedal Strap to the Left
Pedal (22), and adjust it to the desired position.
Attach and adjust the Right Pedal Strap (not shown)
in the same way.
10. The Console (4) requires four "D" batteries (not includ-
ed); alkaline batteries are recommended. Slide the
battery cover off the Console. Insert four batteries into
the battery compartment. Make sure that the batter-
ies are oriented as shown by the diagram inside
the battery compartment. Slide the battery cover
back onto the Console. Note: When the batteries are
installed correctly, the fan will turn on for a moment.
11. Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly
is completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
8
55
79
9
25
22
10
Battery
Cover
8
62
98
42
55
79
60
80
20
7
24
4
Batteries