Assembly - NordicTrack NTC3015.0 User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable wrench and Phillips screw-
driver .
Use the part drawings below to identify the small parts used in assembly. The number in parentheses below
each drawing is the key number of the part, from the PART LIST on page 22. The number following the paren-
theses is the quantity needed for assembly. Note: Some small parts may have been pre-attached. If a part is
not in the parts bag, check to see if it has been pre-attached.
M8 Nylon M10 Nylon M8 Split M10 Split 6.35mm Curved
Washer (71)–8 Spacer (62)—4 Spacer (76)—4
Locknut (79)–4 Locknut (65)–2 Washer (55)–14
M4 x 16mm
M4 x 16mm Round Head M4 x 22mm M6 x 8mm Button M8 x 22mm Button
Screw (57)–6 Screw (60)–2
Screw (80)–4 Screw (59)–2 Screw (54)–6
M8 x 54mm Button M10 x 54mm Button
Screw (56)–4
Screw (52)–4
M10 x 97mm Button Screw (77)–4
5