Important Information On Installing The Mark Iii Navigation System Retrofit Kit - BMW 65 90 0 151 635 Installation Instructions Manual

1.

Important information on installing the Mark III navigation system retrofit kit

Only for use in the BMW dealer organisation.
The Mark III navigation system retrofit kit may only be installed by a specialist workshop that
has the required special tools and manuals (servicing, repair, diagnostics, etc.).
Ensure that the cables/lines are not kinked or damaged as you install them in the car.
Additional cables/lines that you install must be secured with cable ties.
If the specified PIN's and chambers are occupied, bridges, double crimps or twin-lead
terminals must be used.
Item numbers refer only to the overview drawings and to the texts next to the
appropriate figure.
These installation instructions are only valid for LHD cars with a production date after
9/99 with a fitted BMW radio and
without SA 602 on-board monitor with TV and on-board computer
• without SA 606 radio navigation system with on-board computer
• without SA 609 navigation system with TV and on-board computer.
For cars
• without SA 640 telephone preparation with SA 674 hi-fi system
• or without SA 640 telephone preparation with SA 676 hi-fi system
• or without SA 672 CD changer
• or without SA 692 CD changer preparation
the audio module holder installation kit and the left boot cover must also be ordered
separately using the Electronic Parts Catalogue (EPC).
If there is no centre console switch centre in the existing bottom module holder, but only
a single switch (ASC or DSC) a centre console switch centre must be ordered separately
using the Electronic Parts Catalogue (EPC).
The switch module is not supplied with the installation kit and must be ordered separately
using the Electronic Parts Catalogue (EPC).The installation work for the switch module is
described in the installation instructions for the telephone and Mark IIi navigation system
installation instructions.
The map CD is not supplied with the installation kit and must be ordered separately using
the Electronic Parts Catalogue (EPC).
The vehicle holder is to be informed before the installation work that the cigarette lighter
and the ashtray will be removed.
Subject to technical modifications
Tools and equipment required
Cable lamp
Angle cutter
Oscillating saw
Textile adhesive tape
Set of files
8 mm socket
Combination pliers
BMW disconnection tool
Retrofit/Installation kit No. 65 90 0 151 635 (others see cover sheet)
Installation instructions No. 01 29 0 028 872
Set of short Philips screwdrivers
Set of Philips screwdrivers
Set of flat screwdrivers
1/4 inch socket set
1/2 inch socket set
Set of Torx sockets
Set of Allen keys
Issue date: 06.2002
EN/1